The d&s TS switch is a switch that controls dimming and scenes. Buttons 1 to 4 on the d&s TS-4 and buttons 1 to 8 on the d&s TS-8 can be used as pre-set scene switches or as manual individual dimming switches.

The functionality of the individual manual dimming switch is as follows: When button 1 is selected and turned on, you can adjust the dimming by using the UP/DOWN buttons on the right. For the d&s TS-4 switch, buttons 1 and 2 can be used as individual dimming switches, while buttons 3 and 4 can be used as pre-set scene switches. For the d&s TS-8 switch, buttons 1 to 4 can be used as individual dimming switches, while buttons 5 to 8 can be used as pre-set scene switches.

These settings can be configured in the software, allowing customers to download programs to each switch and use them according to their desired switch functionality.

The 4 or 8 switch buttons can be used to control pre-set scenes or adjust dimming using the UP/DOWN buttons located on the right.
Manual dimming control is available for individual and grouped settings.
The dimming status is indicated by LEDs.
Signal transmission range: 4,000ft (1,200 meters).
Address configuration is adopted (000~999).
Lock release function: In cases where control is intended to be performed centrally, either by groups or time schedule, the lock function can be enabled on the switch itself to prevent manual operation. In such situations, facility managers can enter a predefined code by pressing multiple switch buttons, similar to entering a password, to unlock the switch. Once the correct combination of buttons corresponding to the registered code is selected, the switch enters the lock release mode.

The d&s TS-4&-8 switch is connected to the ELC communication line and can directly control manual dimming and dimming scene operations for each dimming module. For example, by programming multiple dimming modules to be linked to the button 1 on the switch, when button 1 is turned on and the right UP/DOWN switch is touched, the dimming will adjust to the desired brightness.

This d&s TS switch is designed to be installed in a 1-gang box or 2-gang box, and it is typically connected using a 4-wire cable. It features buttons with capacitive touch technology. The switch buttons have status monitoring LEDs, and in the middle section of the UP/DOWN buttons, there are LEDs that indicate the status of the dimming.

Here are the additional details about the d&s TS-4&-8 switch:

Drive Power: AC/DC 24V (supplied from the lighting control panel).
Operating Power: DC 5V, 3.3V, and other power sources.
Power Consumption: 15mA.
Operating Conditions: -10 to 60 ℃, 0 to 95% humidity.
Hardware Function and Structure: Touch switches with 1-4 and 1-8 buttons.
MCU: 32-bit Arm Processor (coreTex-M3).
Address Configuration: 000 to 999.
Lock Release Function: Select multiple buttons as if choosing a password.
Cable: 4-Wire (2 cores for power, 2 cores for data).
Mounting Size: Standard 1-gang and 2-gang switch boxes.
1-4 circuit use - 1-gang size (100x50mm).
5-8 circuit use - 2-gang size (100x100mm).
Color: Black and White.